This FLUX AND WORKPIECE CURRENT DENSITY DISTRIBUTION IN LONGITUDINAL FLUX INDUCTION HEATERS
Abstract
This work investigates the distribution of flux density and current density on two types of rectangular workpiece, steel (magnetic) und aluminum (nonmagnetic). The workpiece were subjected to travelling fields, which come a longitudinal flux induction heater.
For the flux density measurements, search coils of 14 mm diameter were used small pins have been distributed on the surface the two workpiece to measure the current density Constantan wire was used with S.W.G-44.
Downloads
References
Davies, J. and Simpson, P.: " Induction heating handbook", McGraw- Hill, Maidenhead, U.K, 1979,
Nasir, B.A.: "Initial study of longitudinal flux induction heaters for magnetic and nonmagnetic slabs", to be published, 1998.
Nasir, B.A: "theory and design of travelling - wave induction heaters for flat metallic workpiece, "Ph.D. Thesis, AL-Mustansiriyah University, College of Engineering, Iraq, 1997.
Burke, P.E. and alden, RT.: " Current density probes ", IEEE trans., Vol. PAS -88, PP 181-185.
[5]Kado, Amer M., ''Eddy current problems in sold cylindrical rotors'', Al-taqani Journal,Vol.7th, No.2, 2004
Copyright (c) 2019 IJRDO - Journal of Electrical And Electronics Engineering (ISSN: 2456-6055)
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
Author(s) and co-author(s) jointly and severally represent and warrant that the Article is original with the author(s) and does not infringe any copyright or violate any other right of any third parties, and that the Article has not been published elsewhere. Author(s) agree to the terms that the IJRDO Journal will have the full right to remove the published article on any misconduct found in the published article.
